Planning starts with demand, not with the size of the old unit. A restaurant needs high recovery for dishwashing and sanitizing during service, a salon needs steady hot water at many stations at once, and an apartment building has sharp morning and evening peaks. Active Plumbing looks at fixture counts, hot water equipment and operating hours to size storage and recovery, then decides whether storage tanks, a multi-unit bank or a tankless array fits your demand pattern.
Next comes capacity. We check that the gas supply, venting, combustion air and electrical service can support the new equipment, and if a larger gas heater needs more than your meter or service line can deliver, coordination with Southwest Gas is planned before installation. The design also accounts for valley water, about 280 parts per million, roughly 16 grains per gallon, so drain and service access and treatment or flushing are part of the plan. In larger buildings, storage temperature, recirculation and avoiding dead legs matter because SNWA notes Legionella can grow in plumbing biofilm.
Finally, schedule and compliance. The permit goes through the building department for your address, relief valves drain to an approved location, and drain pans go where a leak would cause damage. A like-for-like replacement is often done in a day and can be scheduled outside business hours. Commercial water heater installation typically runs $1,500 to $6,000+ in the Las Vegas Valley, with a written price after a site visit. Call (702) 438-3357.